How To Fix A Whirlpool Washing Machine Lid Switch

How To Fix A Whirlpool Washing Machine Lid Switch. If the appliance keeps running, the magnet is in the proper location. Turn off the hot and cold water valves.

How to Bypass Lid Lock on Whirlpool Washer from gentlewasher.com

How to fix a washing machine lid switch turn off the water valves unplug the washing machine from your wall outlet. Once the case is removed you can access the lid switch and replace it. If it does not read any continuity, then your lid switch is indeed faulty.

Source: gentlewasher.com

Turn on the appliance and lift the lid. Once engaged, the switch locks the lid and signals the washer’s control panel to begin a wash cycle.

Source: www.youtube.com

If it does not read any continuity, then your lid switch is indeed faulty. In the hole in the side of the washer cabinet, thread out the trailing wires to remove the lid switch wires from the washer console.

Source: www.pinterest.com

That exposes two clamps one on the right and one on the left, take a screw driver and pry the clamps up and remove them. With your washing machine unplugged from the wall, you’ll now want to shut off the water source.

Source: www.youtube.com

In the hole in the side of the washer cabinet, thread out the trailing wires to remove the lid switch wires from the washer console. Lift the lid of the washer to release the old lid switch.

Source: www.youtube.com

If the door lock is defective, the washer door will not latch properly. You will need better access to the interior, so carefully lay the body down on its front.

Source: www.youtube.com

This is a replacement washer lid switch. Lift the lid of the washer to release the old lid switch.

Open Lid, Lid Switch Is On Back Left Side Of Lid.

With your washing machine unplugged from the wall, you’ll now want to shut off the water source. Once the case is removed you can access the lid switch and replace it. Then remove the grounding wire and the whole wire harness.

Now Remove The Tape From The Washer Lid And Open It The Traditional Way.

Put the lid back down and plug the washing machine back into the electrical outlet. Turn off the hot and cold water valves. If it will raise, then you’re all set!

Remove 2 Screws Behind End Panels, Also Use Nut Driver To Remove 2 Screws Hold Plastic Retraining Straps.

You will need to access the back of the washer, and remove the two phillips screws that hold the top back panel in place. Turn on the appliance and lift the lid. Need help replacing the lid switch (part wp8318084) in your whirlpool washer?

This Is A Genuine Oem Part Made By Whirlpool And Has Been Sourced Directly From The Manufacturer.

Inspect the door lock for damage. Pull apart the wire harness rotate the control console to the back of the washer to expose the lid switch wire. If the door lock is defective, the washer door will not latch properly.

It's Making A Funny Noise And Not Spinning, Or Even Worse, It's Leaking All Over The Floor And You're Panicking.

The lid switch is a very important pa. Disconnect ground wire and squeeze back side of clip on lid switch. That exposes two clamps one on the right and one on the left, take a screw driver and pry the clamps up and remove them.

Lokasi:

Share :